General Assembly Instructions; Dry Vacuum Cleaning - EWT AquaVac COMPACT 10P Instrucciones De Uso

GENERAl ASSEMBlY INSTRUCTIONS

WARNING: DO NOT PlUG IN POWER CORD TO POWER OUTlET, MAKE SURE PlUG IS DISCONNECTED BEFORE ASSEMBlING
ThE WET/DRY VAC
UNPACKING YOUR WET/DRY VACUUM & GENERAl ASSEMBlY
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Turn the locking knobs towards the unlock position. (fig.2)
3. Lift the power head off the container. (fig.3)
4. Remove the contents from inside the container, make sure you have all contents as listed on page 27. (fig.4)
5. Your vacuum comes ready for dry vacuum cleaning with the supplied reusable cloth filter installed. (fig.5)
6. For wet vacuum cleaning, install the supplied foam filter. (fig.6) See page 32 for filter installation.
7. Replace the power head back on the container. (fig.7)
8. Aligning the top section with the latches and turn the latches to the lock position. (fig.8)
9. Insert the hose into the vacuum port. (fig.9)
10. Choose the desired nozzle and insert onto the end of the hose. (fig.10)
28
All manuals and user guides at all-guides.com

DRY VACUUM ClEANING

WARNING: BE SURE TO READ, UNDERSTAND, AND APPlY INFORMATION, ENTITlED 'SAFETY INSTRUCTIONS
& WARNINGS' .
DO NOT VACUUM IN AREAS WITh FlAMMABlE GASES, VAPORS, OR EXPlOSIVE DUSTS IN ThE AIR.
FlAMMABlE GASES OR VAPORS INClUDE BUT ARE NOT lIMITED TO; lIGhTER FlUID, SOlVENT TYPE
ClEANERS, OIl-BASE PAINTS, GASOlINE, AlCOhOl OR AEROSOl SPRAYS.
EXPlOSIVE DUSTS INClUDE BUT ARE NOT lIMITED TO; COAl, MAGNESIUM, GRAIN OR GUN POWDER. TO
REDUCE ThE RISK OF hEAlTh hAZARDS FROM VAPORS OR DUST, DO NOT VACUUM TOXIC MATERIAlS.
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Make sure the filter is completely covering the filter cage against the power head. (fig.2) (Your Wet/Dry Vac comes with the
reusable cloth filter pre-installed, if not, see page 32 for installation instructions.)
3. Place the power head back on the container, and secure it by locking the latches. (fig.3 & 4)
4. Insert the larger end of the hose into the vacuum port on the power head. Push the desired nozzle onto the free end of the
hose. (fig.5 & 6)
5. Ensure the switch is in the 'O' OFF position before plugging into the power supply. (fig.7)
6. Plug in the power cord into the outlet. (fig.8)
7. Turn the motor on by flipping the switch to the 'I' ON position and begin vacuuming. (fig.9)
8. Once you have completed vacuuming, flip the switch to the 'O' OFF position and unplug the power cord from the outlet.
O = OFF I = ON
DO NOT USE ThE REUSABlE ClOTh FIlTER FOR lIQUID VACUUMING.
GB
29