Mve Initial Setup; Mve Changing The Pump Filters - jbc DDVE-B Manual De Instrucciones

DR560 Tip Care
The intake tube should be periodically cleaned by the largest rod.
Important
DO NOT press the vacuum pump button while tinning the desoldering tip, as the fumes given
off by the flux would quickly block the ducts and the air filter.
Desoldering process
Use a tip with a larger diameter than the pad to achieve maximum aspiration and thermal efficiency.
1. Placing 2. Rotating
Place the tip on the When the solder liquefies,
component terminal. gently rotate the tip so that the
compo nent can be lifted off.
After pressing the desoldering key there is a slight delay until the self-contained vacuum pump
stops. This makes sure that the vacuum circuit is completely empty. If any solder remains are left
on a terminal after desoldering it, resolder it with fresh solder and repeat the desoldering operation.
12
3. Aspirating
Press the vacuum pump
button long enough to remove
the solder.

MVE Initial Setup

After connecting the module, enter the Peripherals Menu and select the station
port which you want to join with it.
Peripherals
1. Select the module from the list of peripheral
connections. Remember your first connection
is denoted as "a", the second being "b", etc.
(e.g. MVE_a, MVE_b,...)
2. Press Menu or Back to save changes.
Once set up, you can change the module
settings by entering the Peripherals Menu.

MVE Changing the pump filters

- Clean the casing with a damp cloth. Make sure to use a soft cloth when cleaning the front.
- Periodically check all cable and tube connections.
- Keep filters clean to ensure proper solder suction and replace them when necessary.
Important
Suction filter
Ref. 0821830
Do not use sharp
pointed objects
to open the
suction filter.
Cotton filters
Ref. 0781046
O Ring
Ref. 0007717
Filter cover
Ref. 0004710
w w w.jbctools.com
17:14
Peripherals
Port 2-DR
Pedal None
Module
Module None
MVE_a
None
Spare filters Venturi filter
Ref. 0005966 Ref. 0008446
13