Service And Repair Contact - HURNER HWT 125 SW light Manual De Instrucciones

move are always clean and slightly lubricated with oil
or grease.
• Check the clamps and their locking/tightening mecha-
nism for proper operation.
• Check the PTFE coating of the spigots and sockets.
Their surface should be homogeneous and without
scratches. If the material integrity is compromised or
the piece is damaged, it should be replaced.
• At the end of every job — preferably when the spigot
and socket are still warm —, remove any residues of
the thermoplastic material with a cloth or soft paper.
When removing residues or handling still-warm
sockets and spigots in any way, always wear
heat-resistant protective gloves.
Caution
Using water in any way, e.g., for cooling or clean-
ing, with the machine or the sockets and spigots
is strictly prohibited.
Important
8

Service and Repair Contact

HÜRNER Schweisstechnik
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Web: www.huerner.de
Pursuant to the directive 2012/19/EU on Waste Electri-
cal and Electronic Equipment (so-called WEEE Directive),
equipment that was manufactured or distributed by
ourselves may be returned to us. To discuss the exact pro-
cedure we will follow, please contact us with the details
above.
We also declare that equipment manufacture complies to
the directive 2011/65/EU on the restriction of the use of
certain hazardous substances in electrical and electronic
equipment (so-called RoHS Directive).
14
EN
Tel.: +49 (0)6401 9127 0
Fax: +49 (0)6401 9127 39
E-mail: info@huerner.de
HWT 125 SW light User's Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Version February 2021