Publicidad
Idiomas disponibles
Idiomas disponibles
1a. Remove bumper fascia - remove (5) screws (each side) from bumper
1b. Open the trunk and pull back the weather seal. Use plastic trim tools
fascia, (4) plastic screws and (4) tabs at the bottom of fascia.
to loosen the fascia tab on both sides and disconnect electrical
connector on the passenger side. Gently pull the fascia away from the car.
2. Remove lower existing (4) M8 bolts from bumper mounting.
3. Feed the carriage bolt ① and spacer ② through slots on bottom of
frame rails using the pull wires ⑧. Leave pull wires attached.
©2014, 2015 Cequent™ Performance Products, Inc. - Printed in Mexico
Sheet 4 of 18
24925NP
9-29-15
Rev. C
Publicidad
