Publicidad
Idiomas disponibles
Idiomas disponibles
4a. Tape (4) 1 /4 '' spacers ⑥ on both side brackets (spacer hole aligning
with hitch slots).
5. Make sure hole on the block aligns with slots on bracket. Loosely install
(4) M8 bolts ⑤ and (4) conical washers ⑦ into existing bumper
mounting weldnuts.
©2014, 2015 Cequent™ Performance Products, Inc. - Printed in Mexico
4b. Raise hitch into position, over the exhaust, and feed the pull wires
previously installed through holes on the hitch bar. Remove pull wires
and loosely install conical washer ③ and hex nut ④ to the hitch.
Bend the heat shield if needed.
6. Tighten all M8 CL8.8 fasteners with torque wrench to 20 Lb.-Ft. (27 N*M)
and all 1/2 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M).
Sheet 5 of 18
24925NP
9-29-15
Rev. C
Publicidad
