Starting The Post Driver; Stoping The Post Driver; Disconnecting The Post Driver; When Taking A Break - Atlas Copco LPD-T Instrucciones De Seguridad Y De Funcionamiento

LPD LPD-T, LPD-RV

Starting the post driver

NOTICE In cold conditions, warm up the post driver
by light use for a few minutes before start working.
Always use suitable adaptor for the post and for
●
the post driver. Place the adaptor in the front head
of the post driver by pulling up the adaptor release
ring and slide the adaptor. Release the adaptor
release ring and ensure that the adaptor is
properly secured in the front head of the post
driver.
Remove the protective caps from the quick-release
●
couplings.
● Clean the quick-release couplings if needed and
connect the tail-hoses to the extension hoses of
the power source.
● Insert the post into the post driver. It is possible
to use a optional drive cap.
Lift the post and post driver to a vertical position.
●
For long and heavy posts, two persons may be
required.
Activate the trigger. When the post driver is within
●
reach, grasp the handles.
● Avoid activating the post driver when it is removed
from the post and ground. This will lead to
increased hydraulic oil temperatures and seal
wear.
● Do not invert the post driver without first isolating
the hydraulic supply.
Do not continue to work if the hoses vibrate
●
abnormally.
Investigate the contents of the material in which
●
you are going to work. Look out for hidden cables
and pipes, for example electricity, telephone,
water, gas, or sewage lines.
© 2010 Atlas Copco Construction Tools AB | No. 3392 5036 90 | 2010-04-15
Original instructions
Safety and operating instructions
Only use the machine for the jobs for which it is
●
intended.

Stoping the post driver

Release the trigger. Press the post driver against
●
the surface, until the post driver has stopped
completely.
● Switch off the power supply.
Disconnect the hoses and fit the protective caps
●
on the quick-release couplings.

Disconnecting the post driver

Isolate the hydraulic supply.
●
● Disconnect the hoses by pulling up the locking
rings and pulling up the couplings. Fit blanking
caps to the hoses.

When taking a break

♦ During all breaks you must place the machine in
such a way that there is no risk for it to be
unintentionally started. Make sure to place the
machine on the ground, so that it can not fall.
♦ In the event of a longer break or when leaving the
workplace: Switch off the power supply and then
bleed the machine by activating the start and stop
device.

Maintenance

Regular maintenance is a basic requirement for the
continued safe and efficient use of the machine.
Follow the maintenance instructions carefully.
♦ Before starting maintenance on the machine, clean
it in order to avoid exposure to hazard substances.
See "Dust and fume hazards"
♦ Use only authorised parts. Any damage or
malfunction caused by the use of unauthorised
parts is not covered by warranty or product liability.
♦ When cleaning mechanical parts with solvent,
comply with appropriate health and safety
regulations and ensure there is satisfactory
ventilation.
♦ For major service to the machine, contact your
nearest authorised workshop.
♦ After each service, check that the machine's
vibration level is normal. If not, contact your
nearest authorised workshop.
15