MTD 19A30003OEM Manual Del Operador página 10

2. Install the clevis pin (711-0309A) from hardware pack 689-
00319 into the tractor's hitch and the assembly's hitch support
and secure with a hairpin clip (714-0117). See Figure 4-8.
Note: The clevis pin can be fed down through the hitch
support and secured underneath with the hairpin clip, or
it may be easier to feed the clevis pin up through the hitch
plate hole and secure with the hairpin clip on the topside.
3. Install the two clevis pins with hairpin clips retained earlier,
as shown in Figure 4-8, to secure the top of the hitch
support assembly.
Align hole on bracket
with hole on tractor
4. Tighten all of the hardware securing the hitch support at
this time.
5. Install the upright support bracket onto the mounting
assembly on the tractor by hooking it over the cross
mounting bracket and aligning with the right-side
mounting hole as shown in Figure 4-9.
10 S 4 — A
ection SSembly
Figure 4-8
Figure 4-9
& i
nStAllAtion
6. Secure the bag support assembly to the mounting
assembly using a hex bolt (710-3008) and flange lock nut
(712-04063) packed with the upright mounting bracket.
The support assembly mounts in the right side mounting
hole as seen in Figure 4-10.
Figure 4-10
7. Install the hanger assembly onto the upright support
bracket using the 5/16" carriage bolt packed loosely with
the upright mounting bracket. Simply discard the flange
nut packed with the carriage bolt, and replace it with the
wing knob (720-04122) packed in hardware pack 689-
00319. See Figure 4-11.
Note: The flange nut is extra and will not be needed for this
installation.
Figure 4-11