MTD 19A30003OEM Manual Del Operador página 11

Assembling Remaining Bagger Components
Now that the mounting brackets are assembled and are in place
on the tractor, follow these steps to assemble the remaining
bagger components.
1. Snap the plastic upper chute support in place by first
clipping the side portion onto the bag support rail with
the edge of the snap feature aligned with the red line (1), as
shown in the inset of Figure 4-12.
2. Snap the front portion of the upper chute support to the
bag support rail as seen in 2 of Figure 4-12.
2
Figure 4-12
3. Install the grass catcher cover onto the bag support
assembly, as seen in Figure 4-13. The grass catcher cover
goes inside of the two mounting tabs on the bag support
assembly.
Figure 4-13
4. Slide the hinge pin into the hole located on the mounting
tab, as in Figure 4-14. Use the cut-out window (See inset in
Figure 4-14) to line up the hinge pin on the other side and
push pin all the way in until it reaches the end-stop. At this
point the pin clips into place and is secured by a tab in the
bagger cover. See Figure 4-15.
1
Figure 4-14
Figure 4-15
S 4 — A & i
ection SSembly nStAllAtion
11