Installation - Alpine X800D-U Guía De Referencia Rápida

Installation

X800D-U users
To install the X800D-U, refer to the manual in the
separately purchased installation kit for each car
type.
•
When making connections to the vehicle's electrical
system, be aware of the factory installed components
(e.g. on-board computer). Do not tap into these leads
to provide power for this unit. When connecting the
X800D-U/INE-W987D to the fuse box, make sure the
fuse for the intended circuit of the X800D-U/
INE-W987D has the appropriate amperage. Failure
to do so may result in damage to the unit and/or the
vehicle. When in doubt, consult your Alpine dealer.
•
The Display must be completely retracted in the casing
when installing. If it is not, problems may occur.
1
Before installing, make sure that the
opening and closing of the display will not
interfere with operation of the gear shift.
Movable Display
2
Install at an angle between horizontal
and 30°. Note that installing at an angle
outside of this range will result in a loss of
performance and possibly damage.
0 - 30°
14
-EN
Owner's manual
3
Mounting the Microphone.
For safe use, make sure of the following:
• location is stable and firm.
• driver's view and operations are not obstructed.
• microphone is located where the driver's voice
can be easily picked up (on the sun visor, etc.).
When you speak into the microphone, you should
not have to change your driving posture. This may
cause a distraction, taking your attention away
from safely driving your vehicle. Carefully consider
direction and distance while mounting the
microphone. Confirm that the driver's voice can be
easily picked up at the selected location.
Cable clamp
(Sold separately)
4
Remove the mounting sleeve from the
main unit.
This unit
Slide the unit into the mounting sleeve and
secure it.
Installation
Microphone
Bracket keys
(Included)