Sirius SNOOP Instrucciones De Uso Y De Montaje página 13

INSTALLATION
Before installing the appliance, make sure
that none of the parts is damaged in any way.
In case of damaged parts, contact your retai-
ler and do not proceed with installation.
The manufacturer declines any liability for
damages that may occur during the appliance
handling and installation operations.
Carefully read all of the instructions provided
in this manual, before installing the applian-
ce.
CAUTION: This appliance is made in ceramic
and therefore shall be handled very carefully
, and installed in a professional and proper
manner.
With the help of the drilling template provi-
ded with the appliance, drill the installation
holes in the wall, by using an 8mm diameter
twist drill.
Make sure to install the hood in such a way as
to have a minimum distance of 65 cm betwe-
en its bottom and the cook-top.
Take the wall plate from the packaging and
fix it by using the dowels and screws supplied
(fig.1).
Install and handle the ceramic component
very carefully, as shown in figures 2 and 3.
In order to have the ceramic component
'adhering' to the wall as much as possible,
we suggest you to act on the adjusting screws
shown figures 4 and 5, after installing it to
the wall.
Caution: the ceramic component is hand-
crafted , therefore it is not possible to obtain
regular and uniform shapes on all surfaces.
Screws shall be tightened manually and
lightly, in order to avoid the ceramic to
break up.
Fit the steel bottom component from the
hood lower side (fig. 6), then fix it by using
the eight screws supplied with the appliance.
Connect the led bar power cord by means of
the specific bipolar connector, and then fit
the led bar in its specific seating (see fig.7).
Fit the charcoal filter directly on the steel gre-
ase filter using the specific containment grid,
as shown in figure 8.
Fit the grease filter to the appliance (fig. 9),
connect the steel wire with snap hook to the
filter , then move the grease filter close to the
appliance until it is magnetically coupled to
it.
Connect the appliance to the power supply.
Place the steel grid on top of the hood and fix
it by using the four screws provided with the
appliance. (fig. 10).
13