Sirius SNOOP Instrucciones De Uso Y De Montaje página 15

(within 5 seconds). Leds flashing 6 times in-
dicate the procedure is completed.
WARNING! This operation deletes perma-
nently the preset codes.
Emergency button:
In the event that the radio control does not
work, use the emergency button to switch
the appliance off. After any necessary repairs
have been performed, reset the emergency
button.
WARNIING
The battery should be replaced every year
to guarantee the optimal range of the
transmitter.
To replace the exhausted battery, take
the plastic lid off, remove the battery and
replace it with a new one, observing the
correct battery polarities.
Used batteries should be discarded in
special collection bins.
The below product:
RC001 Radiio Controll
complies with the specifications set out in
the R&TTE Directive 99/5/EC.
WARNING
Any adjustments or modifications which
have not been expressly approved by the
holder of the legal conformity certificate
may invalidate the user's rights relating to
the operation of the device.
The products are endowed with an electronic
device which allows the automatic switching
off after 4 hours working from the last ope-
ration.
Rev. 0 26/08/14
15
TIMING
As a result of the new EU65 "Energy label"
and EU66 "Ecodesign" regulations issued by
the European Commission, which came into
force as from January 1st, 2015 , our pro-
ducts have been adapted to comply with the-
se new requirements.
All of the models complying with the ener-
gy label requirements, are equipped with
new electronics including a timer device
for suction speeds control, when the air ca-
pacity exceeds 650m³/h.
Internal motor models, with maximum air
capacity higher than 650m³/h, are equip-
ped with a timer device that automatically
switches the suction speed from 4
speed, after 6 minutes operation.
The energy consumption of the appliance in
stand – by mode is lower than 0.5W.
to 3
th rd