Replacing The Battery - iHealth BG1 Guia De Inicio Rapido

Remove the lancet from the lancing device. (Tip: Prior to disposal, stick
the lancet into the cover that was snapped off earlier in the process.)
Discard the used test strip and lancet properly.
Note:
Refer to the Cleaning and Disinfecting section of the Owner's Manual for cleaning
and disinfecting procedures.

REPLACING THE BATTERY

Your meter comes with one 3V CR1620 lithium battery already installed. The
battery lasts up to six months depending on the usage. Follow the instructions
below to replace the battery.
1. Turn the meter over with the iHealth logo facing down.
2. Lift off the back cover by pulling firmly from the notch next to the test strip port.
3. Remove the battery by pressing the small white eject button next to the battery tray.
4. Insert the new battery with the "+" side facing up and snap it into place.
5. Press the back panel back in place by inserting the front clip into place and snapping the back of
the cover down.
When the "Battery is low" indicator appears on the app, replace the battery to ensure successful and
accurate measurements.
Disposal – Electrical products should not be disposed of with household waste. Please recycle
where facilities exist. Check with your local authority or retailer for recycling advice.