Vehicle With A Discharged Battery; Transporting Vehicle; Towing; Neutral Lock - E-Z-GO REFRESHER 1200 Manual Del Propietario Y Guia De Servicio

Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
Ref Tlr 2
Fig. 17 Tail and Brake Light Bulb Replacement

VEHICLE WITH A DISCHARGED BATTERY

To reduce the possibility of severe injury or
death from inadvertent motion, do not
attempt to 'jump start' a vehicle.
The vehicle is equipped with a starter/generator and
does not idle. When starting the engine, the starter/gen-
erator functions as a starter and with the engine running,
it functions as a generator.
With the short running times associated with this kind of
vehicle, the generator is more than adequate to maintain
the battery charge level. The generator is not designed to
charge a discharged battery.
When engine starts, the clutches engage and cause
vehicle to move making 'jump starting' both dangerous
and impractical.
If the vehicle battery has become discharged, it must be
charged using a 12 volt charger that is rated at 10 amps
or less. Read and understand all instructions provided by
the manufacturer of the charger.
OPERATION AND SERVICE INFORMATION
Alejar el bisel
del cuerpo
Luz trasera/
freno
Guardabarros
trasero
Owner's Manual and Service Guide

TRANSPORTING VEHICLE

TOWING

This vehicle is not designed to be towed.
It is recommended that the vehicle be moved by placing
the entire vehicle on a trailer, flatbed truck or other suit-
able transport.

NEUTRAL LOCK

To prevent the driven clutch from turning the rear wheels
during service operations, a neutral lock is located on the
direction selector.
To operate:
Turn key switch to 'OFF' and lift seat. Pull out and rotate
the neutral lock pin handle so that the pointed portion of
the handle is to the side of the direction selector cam
(Ref Fig. 18 on page 15). Move direction selector
towards the area between 'F' and 'R'. During that motion,
the pin will snap into the hole in the direction selector
mounting bracket preventing any movement. When in
this position, the direction selector remains locked in the
neutral position. To unlock the direction selector, pull the
neutral lock pin handle out and rotate until the pointed
portion of the handle fits into the hole in the direction
selector cam.
2
1
Desbloqueado
Fig. 18 Neutral Lock
3
Orificio en la leva
del selector de dir
Page 15