E-Z-GO REFRESHER 1200 Manual Del Propietario Y Guia De Servicio página 41

Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
Extension, 3/8" drive, 8" .............................................. 1
Oil drain pan................................................................ 1
Wrench 3/4" ................................................................ 1
For maximum performance and longevity, the engine oil
should be replaced after the first 8 hours of operation.
After the initial oil change, it should be changed every
125 hours of operation or semi-annually, whichever
comes first.
The selection of oil is dependent upon the service that
the vehicle will perform. Most vehicles require 10W-30
oil, whereas vehicles used at capacity or near capacity
load applications will utilize 10W-40 oil after a break-in
period of 100 hours (Ref Fig. 23 on page 21).
HEAVY DUTY WORK
10W-30 10W-30
LIGHT DUTY WORK
0
-20 0 20
F
0
-30 -20 -10
C
(AIR TEMPERATURE)
Fig. 23 Oil Viscosity Chart
If vehicle is to be stored over winter months, it can be stored
with old oil left in engine. The oil should be changed as part of
spring maintenance. This will remove any moisture that has
accumulated during storage.
Be aware that engine fluids may be hot and
contact to the skin may cause severe burns.
Wear rubber gloves to protect skin from
exposure to the old oil and degreaser.
The oil should be changed with engine warm. Park vehicle on a
level surface, engage parking brake and remove key. Place a
drain pan under engine. Wipe top of the engine clean with a
cloth (Ref Fig. 24 on page 21). Remove the oil fill cap.
OPERATION AND SERVICE INFORMATION
10W-40 10W-40
10W-30 10W-30
40 60 80 100
0 10 20 30 40
Owner's Manual and Service Guide
Oil Fill Cap
Fig. 24 Cleaning Top of Engine
Clean the area around filter. Using a filter wrench, strap
wrench or other suitable wrench (A), remove the filter (B)
from the engine and allow the oil to drain. The 'O' rings
may remain on engine or filter (Ref Fig. 25 on page 21)
Fig. 25 Remove Oil Filter
Inspect the filter. Make sure the 'O' ring is not left on the
engine surface.
Page 21