GRE AR-118 Manual De Instrucciones Y Mantenimiento página 6

PROBLEM
The motor will not start up.
After connection, there is no flow to
the discharge valve.
The flow rate of the filter is limited.
The filter leaks through the hose
terminals.
Water comes out through the upper
filter opening.
If your problem can not be solved, contact the pool manufacturer at the telephone and hours indicated in the
instructions.
CAUSE
No power in the electric line.
Loose terminals on the motor.
The suction valve is closed.
The cartridge is dirty due to use.
The hoses are loose or are not
properly inserted in the terminals.
The joint for the upper cover is not
properly adjusted.
HOSE D.25 / D.32
6
SOLUTION
Check that there is power in the
electric line.
Turn on the motor and check the
terminals.
Open the suction valve.
Wash the cartridge.
Insert the terminals until they reach
the bottom of the hoses. Tighten the
clamps.
Remove the flexible seal. Install the
joint properly and close it again.