Normal Maintenance - Chef's Choice 130 Manual Del Usuario

NO lubrication is required for any moving
parts, motor, bearings or sharpening
surfaces. There is no need for water on
abrasives. The exterior of the sharpener
may be cleaned by carefully wiping it with
a soft, damp cloth. Do not use detergents
or abrasives.
Once a year or so as needed, you can
remove metal dust that will accumulate
inside the sharpener from repeated
sharpenings. Remove the small rectangular
clean-out cover that covers an opening on
the underside of the sharpener. (See Figure
11). You will find metal particles adhered to a
magnet attached to the inside of that cover.
Simply rub off or brush off accumulated filings from the magnet with a paper towel or
tooth brush and reinsert the cover in the opening. If larger amounts of metal dust have
been created or if the Stage 3 disk has been cleaned (using the cleaning/dressing tool)
you can shake out any remaining dust through the bottom opening when the cover is
removed. After cleaning, replace the cover securely with its magnet in place.
In the event post-warranty service is needed, return your sharpener to the EdgeCraft
factory where the cost of repair can be estimated before the repair is undertaken. Outside
the USA, contact your retailer or national distributor.
Please include your return address, daytime telephone number and a brief description of
the problem or damage on a separate sheet inside the box. Retain a shipping receipt as
evidence of shipment and as your protection against loss in shipment.
825 Southwood Road, Avondale, PA 19311 U.S.A.
Assembled in the U.S.A.
This product may be covered by one or more EdgeCraft patents and/or patents pending as marked on the
product. Chef'sChoice®, EdgeCraft®, Diamond Hone®, EdgeSelect® and the overall design of this product are
registered trademarks of the EdgeCraft Corporation.
Conforms to UL Std. 982
© 2020 The Legacy Companies.
A20

NORMAL MAINTENANCE

SERVICE
The Legacy Companies
Consumer Support 1-800-342-3255
Certified to CAN/CSA Std. C22.2 No. 64
Certified to EN 60335-1, EN 60335-2, EN 55014-1+A1, EN 61000-3-2, EN 61000-3-3
E/F/S
English — 12
Figure 11. Clean-out cover.
chefschoice.com
Printed in China.
C139604