FINO FORNO S Manual Del Usuario página 24

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

7.4 Programming
Activate programming mode, select program
Pic. 28: LED Prog.
Pic. 29: Operating display, LED blinks
Programming of steps, temperatures,
holding times
Pic. 30: Step 1
Pic. 31: Enter heating speed
18
The controller offers the option to store up to
nine different heating programs.
1. Press⇨key until the LED below
"Program number" display is on.
2. Select program (1-9) with Plus and
Minus keys (here e.g.: program 1).
3. Keep the Prg key pressed until the
operating display indicates ready-for-input.
The LED blinks.
NOTE!
If no selection has been made within
10 seconds using the Prg key the displays
switches back to the normal display mode.
In the programming mode individual heating
curves can be compiled by the selection of
up to 4 steps.
Enter heating parameter for step 1:
1. Select heating speed (C/min) with Plus and
Minus keys (here e.g.: 9 °C/min).
NOTE!
If "0" is selected the furnace heats with
the maximum heating speed (> 9 °C/min)
non-linear.
Pic. 32: Enter temperature
Pic. 33: Enter holding time
Pic. 34: Additional steps
Quit programming mode
ENU
2. Select temperature (C) with ⇨ .
3. Enter temperature with Plus and Minus keys
(here e.g.: 1150 C).
NOTE!
Maximum temperature: 1500 °C.
4. Select holding time (min) with ⇨key.
5. Enter holding time with Plus and Minus keys.
NOTE!
Maximum holding time: 99 minutes.
After holding time has terminated you will
hear a beep. Nevertheless the furnace will
hold the temperature until the operator
quits the program.
6. If necessary select another step using
⇨key and Plus and Minus keys
(here e.g. second step).
7. Repeat program steps 1 to 5 for more steps.
After the respective heating parameterss for a
step have been programmed the programming
mode can be quitted.To quit the programming
mode keep the Prg key pressed until the LED
below the operation display in permanently on.
The program is now permanently saved.
NOTE!
If a program should only consist of one single
step it is important to make sure that all
values in the further steps are set to "0"!
19

Publicidad

Capítulos

Tabla de contenido
loading

Productos relacionados para FINO FORNO S

Este manual también es adecuado para:

Forno l4318643187

Tabla de contenido