Kohler K-1737 Guia De Instalacion página 8

5" (12.7 cm)
from Ceiling
3/8" (1 cm) D.
Apply silicone sealant.
4. Install the Temperature Sensor
IMPORTANT! Do not locate the temperature sensor directly above the steam outlet. Follow the
designated target locations for your module found in the "Steam Hardware Location" section.
Make sure that the power is turned off at the main breaker panel before proceeding.
Locate the temperature sensor on the wall 5" (12.7 cm) down from the ceiling.
At the selected location, drill a hole 3/8" (1 cm) in diameter.
IMPORTANT! Do not pinch, nail, wedge, or use undue force when handling the temperature sensor wire.
Any damage to the wire may result in temperature sensor failure. If the temperature sensor is not installed
immediately, protect the end connector with tape or other shielding material.
IMPORTANT! When installing the temperature sensor, allow room in the sensor wire for a drip loop. The
drip loop will discourage moisture from following the sensor cable to the steam generator.
Insert the temperature sensor wire through the drilled holes.
Route the temperature sensor wire behind the wall to the steam generator. Connection to the steam
adapter to follow.
Apply a small bead of silicone sealant around the back side of the sensor housing where it will
contact the wall. Wipe off any excess sealant and do not let any sealant contact the sensor probe.
Press the sensor firmly onto the wall.
Allow the silicone sealant to cure before use.
1069332-2-B
Temperature
Sensor
Back View
Drip Loop
8
Apply silicone sealant.
Kohler Co.