Machine Adjustment Procedures; Abrasive Assembly Procedures - Kunzle & Tasin Bona CombiEdge Short Manual De Funcionamiento

Starting the Machine (Cont.)
6.
Raise the disc so that the machine is only resting on the floor
with its wheels. Then, press and hold the switch (A).
8.
To stop the machine, raise the disc so that the machine is only
resting on the floor with its wheels. Then, release the switch
(A).

Machine Adjustment Procedures

Abrasive assembly procedures

If velcro-backed abrasive is to be used, proceed as follows:
1) Ensure the electric cable is disconnected from the power.
2) T urn the machine over, resting the handles on the floor.
3) Remove the worn abrasive paper disc (A) from the
velcro-backed disc.
4.
12
5.
Bona CombiEdge™ Short/Long Manual
®
7.
Keep the machine moving when the abrasive disc is lowered
and in contact with the work surface.
The switch must be kept pressed to operate the machine.
The machine gradually stops when the switch is released
or the power supply is interrupted.
The disc does not stop immediately! Take care not to touch
it with any part of the body during this phase.
4) Ensure the surface of the velcro-backed disc is clean and
position a new 150mm (6.00") diameter abrasive disc.
5) Attach the abrasive disc, securing it well to the velcro.