To transfer stored data to PC keep to the following procedure:
1.
Turn on the instrument pressing the power key
2.
Connect the instrument to a PC by means of the opt insulated cable provided with the
software package. Communication is enabled at any function except for measurements
as well as when memory management is active (§ 5)
3.
Use the data management software to download the instrument's stored data to a
PC. During the data transfer the instrument displays a screen as beside, then after
completing the data transfer goes back to the previously selected mode
8. MAINTENANCE
8.1 General
This is a precision instrument. Strictly follow the instructions for use and storage reported in this
manual to avoid any possible damage or danger during use.
Do not use this tester under unfavorable conditions of high temperature or humidity. Do not
expose to direct sunlight.
Be sure to turn off the tester after use. If the instrument is not to be used for a long period you
are recommended to remove batteries to avoid leakages of battery liquid which may damage its
internal circuits.
8.2 Battery Replacement
When the low battery indication
�CAUTION
Only skilled technicians can open the instrument and replace batteries. Before removing
batteries disconnect all cables from input terminals
1.
Turn off the instrument pressing the ON/OFF key for a while
2.
Disconnect the cables from the input terminals
3.
Remove the battery cover screws and detach the battery cover
4.
Replace batteries with new ones of the same type (§ 9.2.2) keeping to the right polarity
signs
5.
Replace cover and screws
6.
Use the appropriate battery disposal methods for your area
8.3 Instrument Cleaning
Use a soft dry cloth to clean the instrument. Do not use wet clothes, solvents, water etc.
=
8.4 End of Life
Caution: this symbol indicates that equipment and its accessories shall be subject to a separate
collection and correct disposal.
is displayed the batteries are to be replaced.
20