Disposal; Troubleshooting - Vornado VH200-EU Manual Del Usuario

DISPOSAL

IMPORTANT NOTES
PACKAGE RECYCLING: The packaging protects the appli-
ance from transport damage. The packaging materials are
selected from the point of view of their environmental friend-
liness and disposal technology and are therefor recyclable.
† Dispose of all packaging materials in an environmentally respon-
sible manner.
IMPORTANT NOTES
WEEE Recycling
† Waste Electrical and Electronic Equipment Disposal: This
marking indicates that this product should not be disposed with
other household wastes throughout the EU. To prevent possible
harm to the environment or human health from uncontrolled
waste disposal, recycle it responsibly to promote the sustainable
reuse of material resources. To return your used device, please
use the return and collection systems or contact the retailer where
the product was purchased. They can take this product for envi-
ronmental safe recycling.
12 English

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE AND SOLUTION
Unit fails to power on. Unit is not plugged in. Plug Power Cord into electrical outlet.
Household circuit breaker / ground fault interrupter has tripped or blown a fuse. Reset circuit breaker /
ground fault interrupter, or replace fuse. See IMPORTANT INSTRUCTIONS.
The unit has overheated. Automatic Safety Shut-Off has initiated. See RESET HEATER.
Tip-over switch on bottom of unit has been tripped and safety shut-off system has cut power to heater.
Place heater on level surface. See SAFETY FEATURES.
Unit is damaged or in need of repair. Cease usage and unplug.
Unit is not producing Ensure unit is set to High Heat and thermostat is set to highest Temperature setting.
sufficient amount of heat.
Close all doors and windows to trap heat.
Allow the unit to fully circulate the heat throughout the room, may take several minutes.
Unit is powered on but Power off and unplug the unit. On the bottom of the unit, there is a black disk. Push in 4-5 times ensuring
there is no heat. it is not stuck. Set unit down on flat surface. Be sure power cord is not under unit. Plug unit in and power
on. Turn to highest heat setting.
English
13