Connecting The Pdu - Tripp-Lite AGPD7989 Serie Manual Del Propietário

3. Installation
3.1-5 Reduced-Depth Mounting: Use
three screws to attach each of the
two shorter mounting brackets to
the PDU as shown. Mount the PDU
to a stable surface with the outlets
facing upward by inserting two or
more user-supplied screws through
the mounting brackets and into
secure mounting points.

3.2 Connecting the PDU

3.2-1 Input Power Cord Connection:
Attach the cable clamp to the PDU
by inserting the tabs into available
slots on the top and bottom of the
power inlet
by sliding it to the right. Attach the
included power cord to the PDU by
inserting the IEC C19 connector
of the power cord into the cable
clamp and IEC C20 power inlet
Install the included screw
the cable clamp to secure the
power cord connection. Connect
the other end of the input power
cord to a compatible source of AC
power, such as a UPS system, PDU
or utility outlet.
Note: The AC power source should not
share a circuit with a heavy electrical
load.
Note: When connecting the PDU, it
should be provided with over-current
protection and a maximum 20A
branch-rated over-current protection
device.
15-04-184-93341C.indb 7
. Secure the clamp
A
B
.
C
on
D
3.1-5
3.1-5
B
3.2-1
7
A
C D
4/16/2015 8:49:10 AM