Monster Power 100 Manual De Usuario página 6

ENGLISH
Serial Code
Locate the sticker on the Monster Remote Access RF/IP Card 100 containing
the serial code prior to installation. The serial code will look like the following:
Write down the serial code, you will need it later when configuring
the PowerCenter on the Monster website.
Installation
Install the Monster Remote Access RF/IP Card 100 into the Monster PowerCenter
prior to placing the PowerCenter into a rack or closet.
Card Installation
Use these steps to install the Monster Remote Access RF/IP Card 100.
• Disconnect the PowerCenter from all power.
• Ground yourself by touching the metal case of the PowerCenter.
• Locate the SNMP slot on the back of the PowerCenter.
This SNMP slot is located on the left side when facing the backplate
of the PowerCenter. The slot will be covered with a plastic cover plate.
MPC12345/ABCD