Preparation
•
Put the power switch to OFF position (Center).
•
Install 3 pcs C type Alkaline batteries into the battery compartment on the right for Motion
sensor working.
•
Install 4 pcs D type Alkaline batteries to the compartment on the left for Digital Camera
operation.
•
Install an SD card (32GB max). Be careful to insert the SD card according to direction
shown on the SD card. Before replacing a SD card, be sure the PW switch is already at OFF
position in order to avoid the data in the SD might be flushed. After that, format the SD
card firstly before operation.
(see figure next page)
Display 2.4"
Memory Additional: SD card (max 32GB) (not supplied)
Video recording 3 - 90 secs
Connections
Additional Features
Dimensions, weight 15,5 x 19 x 9cm (WxHxD), 510grs
Scope of Delivery
First Steps
TV Out (PAL/NTSC), connector for external so-
lar panel; USB;
•
Time stamp (date & time)
•
2 modes: battery saving / Turbo snap shot
•
Infrared flash
•
PIR Pause (0, 1, 3, 5, 10, 20, 30, 60min)
•
Quick Shot mode
•
Burst Mode for a series of 5 photographs
•
Display icons: Low batt. / memory full /
Video mode / PIR sensor / walk test
•
PIR sensor sensitivity adjustable
•
Device
•
TV-Out cable
•
USB cable
•
Belt strap
•
User manual
21