Vollrath LidSaver LS01 Manual Del Operador página 3

LOADING
1. Before loading lids, verify your lids match the manufacturer and lid
number noted on the lid plate label.
2. Separate the lids prior to loading to release any lids that may have been
pressed together during packaging.
3. Load lids or cups.
• Lids must be loaded with the front of the lid stack facing forward.
NOTICE: DO NOT overstock lids. Compressing lids may result in
dispensing problems.
4. If dispensing tabbed lids, align all lid tabs either up (12:00) or
down (6:00) to avoid interference with the lid claws.
NOTICE: Each LidSaver™ is factory set to dispense a particular lid. If
you change manufacturers or sizes, your LidSaver™ will
need to be modified. Vollrath offers lid change out kits that
are easy to install. Visit www.Vollrath.com for more
information.
™
LidSaver In-Counter Lid Dispensers Operator's Manual
CLEANING
NOTICE: Do NOT use strong solvents or commercial cleaners
containing ammonia, alcohol, acetone or dry cleaning
products. These will damage the equipment.
Regularly clean the inside and outside of your LidSaver™.
1. Remove all lids from LidSaver™.
2. Remove the bezel/housing (refer to installation instructions).
3. Wipe the interior and exterior with a cotton cloth and warm soapy
water.
4. Saturate each pager assembly with warm soapy water several times.
Flex the flipper portion of the pager to verify flippers operate freely.
5. Push the piston to the back of the tube to expose the bottom of tube.
Wipe the bottom of the tube.
6. Lubricate components:
• Door pivots: Apply lubricant with the door fully open and closed.
• Housing screws
7. Replace the housing.
8. Reattach the door springs.
MAINTENANCE
Tune-Up Your LidSaver™
When lids do not dispense correctly your LidSaver™ may need to be
adjusted. Order a tune-up kit. See www.Vollrath.com for ordering
information.
3