Adhesive Putty Installation - SRAM QUARQ Manual Del Usario

A D H E S I V E P U T T Y I N S T A L L A T I O N
The included adhesive putty will permanently attach the magnet to your frame. Other non-­permanent
attachment options include: hot glue, some epoxies, electrical tape, or similar adhesives.
Installation Notes: Do not allow the magnet to contact the power meter. When properly installed, the
magnet should be in line with the cadence sensors and within 2-­8 mm (1/16"-­3/8") of the sensors.
Depending on your frame, you may need to stack 2-­3 magnets to achieve this distance.
1.
2. Clean the frame with the included alcohol pad prior to attaching the magnet.
3.
4. Place a 6 mm (1/4") diameter ball of putty on the back of the magnet, and then press the magnet onto
the frame. The center of the magnet should be positioned between 30 mm and 38 mm (1 1/8"-­1 1/2")
from the center of the bottom bracket.
5.
minutes, and will cure in 1 hour.
6. Reinstall the cranks.
7.

ADHESIVE PUTTY INSTALLATION

9