Rockwell Automation Allen-Bradley PanelView 300 Instrucciones De Instalación página 10

10 PanelView 300 Keypad Terminals
5. Install the 4 self-locking nuts, hand tight.
Protective
Installation
Label
6. Alternately tighten the self-locking nuts until the terminal is held firmly
against the panel. Tighten the nuts to a torque of 10 in-lb (1.13 Nm). Do not
overtighten nuts.
ATTENTION
!
7. Remove the protective installation label covering the top vents of the
terminal.
ATTENTION
!
Publication 2711-IN027B-MU-P
Mounting nuts must be tightened to a torque of 10 in-lb
(1.13 Nm) to provide a proper seal and to prevent
potential damage to the terminal. Allen-Bradley assumes
no responsibility for water or chemical damage to the
terminal or other equipment within the enclosure
because of improper installation.
Failure to remove the protective installation label
covering the top vents could result in overheating and
damage to the terminal.
Self-Locking Nuts
(4 used, 6 provided)
Mounting Studs
(2 left / 2 right)