Installing Terminal In Panel - Rockwell Automation Allen-Bradley PanelView 300 Instrucciones De Instalación

Installing Terminal in Panel

To install the PV300 keypad terminal in a panel:
ATTENTION
!
1. Cut an opening in the panel using the panel cutout provided with the
terminal. Remove sharp edges or burrs.
2. Make sure the sealing gasket is properly positioned on the terminal (as
shown below). This gasket forms a compression type seal. Do not use
sealing compounds.
Legend Strip
3. Verify that the end of the legend strip is fully inserted and does not interfere
with the sealing gasket.
4. Place the terminal in the panel cutout.
Disconnect all electrical power from the panel before making
cutout.
Make sure the area around the panel cutout is clear.
Take precautions so that metal cuttings do not enter any
components that may already be installed in panel.
Failure to follow this warning may result in personal injury or
damage to the panel components.
PanelView 300 Keypad Terminals
Sealing Gasket
Publication 2711-IN027B-MU-P
9