Rockwell Automation Allen-Bradley PanelView 300 Instrucciones De Instalación página 13

To connect DC power to the PV300 keypad terminal:
1. Secure the DC power wires to the terminal block screws.
IMPORTANT
2. Secure the Earth Ground wire to the correct terminal block screw.
ATTENTION
!
3. Apply 24V dc power to the terminal.
Power Terminal
Block (fixed)
The terminals are rated for 30 - 14 AWG copper wire. Tighten to
5 in-lb (0.57 Nm)
Explosion Hazard - Do not connect or disconnect
equipment while circuit is live unless area is known to be
non–hazardous.
Do not apply power to the terminal until all wiring
connections have been made. Failure to do so may result
in electrical shock.
+
Earth Ground
DC Negative
DC Positive
PanelView 300 Keypad Terminals
Publication 2711-IN027B-MU-P
13