Channel Features - Alesis MultiMix 12 FireWire Manual De Inicio Rápido Para El Usuario

CHANNEL FEATURES

4
1. EQ: Boosts or cuts the respective frequencies for
each channel. When recording via Firewire, the
EQ settings ARE recorded.
2. AUX A: Routes channel signal to an external
device like an effects processor. (PRE or POST
fader depending on switch position.
3. AUX B: Controls level routed to internal effects
processor or routes channel signal to an external
device like an effects processor.
When recording via Firewire, the AUX A and B
signals are NOT recorded on the individual
channels. They ARE recorded via the MAIN
MIX channels.
4. PAN/BALANCE: Assigns the channel signal to
any spot in the mono or stereo spectrum.
When recording via Firewire, the MONO
channels' pan position is ignored when recording
the individual channel but is captured when
recording the MAIN MIX channels. The
STEREO channels' balance is captured by both
the individual channel and the MAIN MIX
channels.
5. PFL/SOLO: Allows the channel signal to be
heard before being affected by the fader.
6. MUTE/ALT 3/4: Mutes the channel signal
heard in the MAIN OUTPUT and routes the
signal to the ALT 3/4 OUTPUT.
These settings are ignored by the Firewire
individual channel outputs.
7. CHANNEL FADER: Controls the MAIN
OUT (analog) and Firewire (digital) signal level
of the MIC or LINE inputs.
S/PDIF CABLE: We recommend that you use a cable
that is specifically designed to carry a digital signal and
does not exceed 5 meters (16.4 ft) in length.
* Use only high quality cables for digital transfers*