Roberts 10-63 Manual De Operación página 3

FIGURE 1
FIGURE 2
FIGURE 3
ASSEMBLY
Assemble the table assembly (Fig.
1-A) Fig.1 to the blade assembly
(Fig. 1-B) using 4 small Phillips head
screws (Fig. 1-C) to secure the top of
the table. Use two larger pan head
screws (Fig.1-D) to secure the table
brace.
Assemble the handle (Fig. 2-A) to
the top of the blade assembly. First,
loosen the three fixing screws (Fig.
2-B) using a hex key. Insert the
handle shaft into the cylindrical hole
(Fig. 2-C), make sure the recessed
hole (Fig. 3-D) lines up with the
center screw. Once properly aligned
and inserted, tighten the center fixing
screw using a hex. key. Then tighten
the other two fixing screws.
SETTING UP FOR OPERATION
The laminate flooring cutter is
shipped with the blade assembly
in the down and locked position.
This safety feature ensures that
the cutting edge of the blade is not
exposed during transport or storage.
To unlock the blade assembly, loosen
the safety lock knob (Fig. 3-A),
depress the handle then slide the
lock knob to the right to disengage
the lock (Fig. 3-B).
WARNING Secure handle in the
down position and re-engage the
safety lock before storing, carrying or
transporting your laminate flooring
cutter.
- 2 -
SET UP