Gryphon™ M Default Configuration - Datalogic GRYPHON M Serie Guía Rápida

GRYPHON™ M
GRYPHON™ M DEFAULT CONFIGURATION
DATA FORMAT
code identifier disabled, field adjustment disabled, code length tx not
transmitted, character replacement disabled.
POWER SAVE
scan rate 270 scans/s.
READING PARAMETERS
operating mode hand-held, hardware trigger, trigger active level, no timeout,
Flash On = 1 sec, Flash Off = 0.6 sec, one read per cycle, safety time 0.5
sec, beeper intensity high, tone 2, beeper type monotone, beeper length
short, good read spot duration medium
DECODING PARAMETERS
ink spread enabled, overflow control enabled, interdigit control enabled,
Puzzle Solver™ disabled, decoding safety = one read
CODE SELECTION
M200
M100
M200
M100
M200
ADVANCED FORMATTING PARAMETERS
concatenation disabled, no advanced formats defined
RADIO PARAMETERS
radio protocol timeout = 2 seconds, power-off timeout = 4 hours, single store
disabled, beeper control for radio response = normal
Code PDF417
EAN 8/EAN 13 / UPC A/UPC E without ADD ON
check digit transmitted, no conversions
Interleaved 2/5
check digit control and transmission, variable length code;
4-99 characters
Standard Code 39
no check digit control, variable length code; 1-99 characters
Code 128
EAN 128, ISBT128, Code 93, Codabar, pharmaceutical
codes, Codablock-A, Codablock-F Standard and EAN, MSI,
Plessey, Telepen, Delta IBM, Code 11, Code 16K, Code 49
enabled codes
disabled codes
UK/US
7