Using Gryphon™ M Series Readers - Datalogic GRYPHON M Serie Guía Rápida

UK/US
USING GRYPHON™ M SERIES READERS
The Gryphon™ M series reader, paired with an OM-GRYPHON cradle, builds a
Cordless Reading System for the collection, decoding and transmission of
barcoded data.
Gryphon™ M readers automatically scan barcodes at a distance. Simply aim
and pull the trigger. Code scanning is performed along the center of the light
bar emitted from the reading window. This bar must cover the entire code.
READING ANGLE
Successful scanning is obtained by tilting the reader with respect to the
barcode to avoid direct reflections which impair the reading performance, see
the figure below.
Successful reading is obtained by an audible tone plus a good-read green spot.
Good read LED
To start using your Gryphon™ M reading system you must:
1. Connect an OM-GRYPHON cradle to the Host. For installation and
connection information see the OM-GRYPHON Quick Reference Manual.
2. Charge the Gryphon™ M battery using an OM-GRYPHON / C-GRYPHON
charger as described in this Quick Reference manual. A full charge takes
3.5 hours with NiMh battery models.
3. Configure the reader as described in this Quick Reference manual.
4. Configure the OM-GRYPHON cradle. See OM-GRYPHON Configuration in
the "OM-GRYPHON Quick Reference".
2
Good read spot
OK
DATALOGIC
Not Advised