Heath Zenith 6117 Manual De Instrucciones página 11

SyMPTOM
Light does not stay
on in AUTO mode.
Light turns on in
daylight in the AUTO
mode.
This product is to be installed indoors only.
Electrical Input ........................................................................................................................120V, 60 Hz.
Fluorescent Load .............................................................................................. Up to 400 Watts Maximum
Motor Load ...........................................................................................................Up to 1/8 HP Maximum
Incandescent ...................................................................................Up to 500 Watts Maximum at 120VAC
On-Time ................................................................................... Selectable, approximately 5 to 30 minutes
Photocell Sensor ....................................................................From full daylight to less than 1 FC (10 lux)
Coverage ........................................ up to 15 ft. (4.6 m) at 150°, up to 30 ft. (9.1 m) in front of the sensor
598-1373-01
POSSIBLE CAUSE
1. Motion has stopped in the room.
2. TIME control is set for too short a
delay.
LIGHT control not set properly.
SPECIFICATIONS
1. Continue movement.
2. Set switch TIME control to longer
time period.
Turn the LIGHT control counter-
clockwise (see Light Sensitivity Level,
page 8).
11
SOLUTION