Heath Zenith 6117 Manual De Instrucciones página 6

TESTING
IMPORTANT: When sliding the control
switch from OFF to AUTO, there is a 1
minute warm up period before the control
will become fully functional.
IMPORTANT: In AUTO mode, if the sensor
turns the light off, there is an 8 second
delay before the sensor will turn the lights
on when motion is sensed.
IMPORTANT: When using the remote switch
to turn the light off or on, wait at least 8
seconds before using the switch again.
1. Remove the decorative cover plate, if installed
(secured by two small screws).
2. Remove control panel cover by gently pressing
in with screwdriver and prying cover off (see
Figure 5).
Decorative
Cover Plate
Screwdriver
Figure 5 - Removing Control Panel Cover
OFF ON
AUTO
3. For test purposes, use a small, phillips screwdriver
to turn the TIME control to the TEST position
(see Figure 6).
4. Use the flowchart on page 7 to test control switch
wiring.
10
5
5
Test 30
T I M E
Figure 6 - Control Panel
6
+
20
L I G H T
598-1373-01