Preparation And Taking Into Operation; Commissioning Jetstamp 790/790 Mp; Commissioning Jetstamp 792/792 Mp - Reiner jetStamp 790 Instrucciones De Empleo Breves

jetStamp 790/790 MP
jetStamp 792/792 MP

1. Preparation and Taking into Operation

1.1. Commissioning jetStamp 790/790 MP

Only connect the device to the PC after the 790 PCset easy software has been installed.
The batteries must be completely charged before using the stamp for the first time.
This takes about 14 hours.
Inserting rechargeable batteries
Open the battery compartment
f
Check for correct polarity and insert the batteries.
f
Close the battery compartment
f
Charge batteries
Put the jetStamp 790 in the charging station
f
Connect the Mini-USB socket
f
USB cable.
Connect mains unit to the mains.
f
Batteries are charged when the green charging control light
f
Charging condition is displayed by the symbol
f
Troubleshooting
The following message appears in the display
"EMPTY BATTERY - NO IMPRINT POSSIBLE".
The batteries have not been recognised by the system.
Press any key.

The display
Unallowed inputs may have been made.
Press the reset button


1.2. Commissioning jetStamp 792/792 MP

Only connect the device to the PC after the 790 PCset easy software has been installed.
Connect jetStamp 792 to the connection electric stamp of the adapter.
f
Connect mains unit to the connection voltage supply of the adapter.
f
Push mains unit into the socket.
f
12
The display
21
2
2
.
Fig.
A D
 +
7
of the charging station
12
is dark or lines appear.
3
.
shows "INPUT - TIME 1".
Fig. B

on the back of the stamp.
4
with the locking tab
in the display
12
after inserting batteries
8
first.
4
with the mains unit with the
6
is lit.
12
after a few minutes.