Powerreclinexr With Massage & Heat Assembly Instructions - La-Z-Boy XR Instrucciones De Operación

PowerReclineXR
Assembly Instructions
NOTICE:
Do not plug in until instructed.
1. Carefully cut the plastic tie holding the power supply box and the hand wand to the
body bracket (F 1).
IGURE
2. Remove the hand wand from the bubble wrap, and lay the hand wand on the seat.
WARNING
– To reduce the risk of injury:
• Do not operate the unit until the back is installed and locked.
3. Install the back.
Lay the back across the arms of the chair. Turn the locking levers, located on the brackets attached
•
to the back (one on each side), to a 90 degree angle (F
cables between the rear of the seat and the metal rear rail (F
become pinched while installing the back.
Lift the back at a slight angle and align the brackets on the back with the brackets on the
•
body (F 3).
IGURE
Lower the back onto the body, making sure the back and body brackets are completely engaged.
•
To make sure the back is properly installed with both sets of back and body brackets
-
engaged, stand behind the chair and twist the back from side to side. If one or both sides
move out of position the brackets are not engaged (F
the steps above.
If you are unable to install the back properly, contact your La-Z-Boy
-
• Lock the brackets by using a screwdriver to push down the locking levers (F
4. To access the connectors, gently roll the chair forward to rest on the arms and the top of the back.
The connectors are located at the back of the chair, under the rear seat.
5. Identify the electrical connectors (F
IGURE
• The rectangular red connectors are for the heating pad connection.
The rectangular brown and black connectors are for the massage connection.
•
The round black connector is for the power supply connection.
•
(Assembly Instructions Continued)
8
with Massage & Heat
®
5). Route the massage and heating pad
IGURE
2). Do not allow the cables to
IGURE
4). Remove the back and repeat
IGURE
® dealer for assistance.
5).
IGURE
6).
PowerReclineXR
®
Assembly Instructions
F 1
IGURE
Hand Plastic Power
Wand Tie Supply Box
F 3
IGURE
Body
Bracket
Back Bracket
F 5
IGURE
Back
Locking
Bracket
Lever
at 90
Degree
Angle
Locked
Position
with Massage & Heat
F 2
IGURE
Massage & Heat Cables
Metal Rear Rail
F 4
IGURE
Back and body brackets on this side are not
engaged. Remove the back and reinstall.
F 6
IGURE
Power Supply
Power Supply
Connector
Connector
Massage Heating Pad
Connectors Connectors
9