La-Z-Boy XR Instrucciones De Operación página 9

PowerReclineXRw
Assembly Instructions
WARNING
– To reduce the risk of serious injury:
• Provide a clear path for operation of the back and legrest. Place tables and area rugs
at a distance to allow the legrest to fully extend without rubbing or interference.
5. Adjust the glides to ensure a height that provides a clear path for operation of the legrest. Each glide is
attached to the base rail by one jam nut and one lock washer on top of the base rail, and one jam nut
on the bottom of the base rail.
To extend the glide, loosen the upper jam nut by rotating clockwise. Turn the lower jam nut
•
clockwise to the desired height.
Tighten the upper jam nut by rotating counterclockwise.
•
Repeat steps one and two for each adjustable glide on the unit, if needed.
•
Repeat this procedure, as necessary, to adjust the front height of the unit and level it.
•
Lock
Washer
Base Rail
6. Locate the motor connector, one behind each reclining seat (F
console, use the Y-cable and connect the two long leads to the two motor connectors; all other sofas
connect directly to the power supply.
For a reclining loveseat with console, align one motor connector to a long lead Y-cable connector,
•
push the connectors together until fully seated and close the locking cover to secure the connection
(F 8). Repeat this for the other motor connector and Y-cable long lead. Then align the short lead
IGURE
of the Y-cable to the power supply connector, push the connectors together until fully seated and
close the locking cover to secure the connection (F
For all other sofas, connect one power supply to each motor connector. Align the motor connector
•
to the power supply connector, push the connectors together until fully seated and close the locking
cover to secure the connection (F
IGURE
7. Connect the 120 volt power cord to the power supply (F
the Operating Instructions.
8. Proceed to the Battery Backup Assembly Instructions.
To Remove a Back:
1. Unplug the 120 volt power cord from the electrical outlet and disconnect the power supply from
either the Y-cable or motor connector, whichever comes with the product.
2. Taking care not to damage the cover, insert a screwdriver between the arm and back and engage
the locking lever on the back bracket (F
3. Push up on the locking lever until the lever is at 45 to 30 degrees from vertical (F
4. Repeat steps 2 and 3 for the other side of the back, inserting the screwdriver between
the rear post and back.
5. The back is free to remove at this point. Lift up on the back to remove.
(Assembly Instructions Continued)
16
™ Motion Sofa
Upper Jam Nut
Lower Jam Nut
Adjustable Glide
7). For a reclining loveseat with
IGURE
9).
IGURE
10).
11). Do not plug in until instructed in
IGURE
12).
IGURE
F
IGURE
F
IGURE
Make this
connection
Y-Cable Short Lead
F
IGURE
Power Supply
12).
IGURE
PowerReclineXRw ™
Assembly Instructions
7 F
Motor Connectors
9 F
Power Supply Power Supply
11 F
Back
Make this
Bracket
connection
120 Volt Power Cord
Motion Sofa
8
IGURE
Make these
connections
Y-Cable Long Leads
10
IGURE Motor Connector
Make this
connection
12
IGURE
45 Degrees
from
Vertical
Locking
Lever
17