Battery Backup Assembly Instructions; Powerreclinexr ® & Powerreclinexrw; Power Supply Specifications - La-Z-Boy XR Instrucciones De Operación

Battery Backup Assembly Instructions

Replace the power supply batteries every six months and after
NOTICE: each power failure use. Under normal conditions, the battery
backup will operate the chair two times, but this performance
cannot be guaranteed.
The performance of the built-in battery backup cannot be guaranteed. If you require continuing
use during a power outage, you should purchase a separate battery backup system. Contact
your La-Z-Boy ® dealer for more information.
To reduce battery consumption, the massage and heat features are blocked and unavailable
when the battery backup is in use. Additionally, the operating speed is reduced to decrease
energy consumption.
Always maintain constant even pressure on the button when operating on battery backup to
reduce the energy consumption.
The battery backup is located in the power supply and uses two 9-volt alkaline
batteries (not included).
1. Unplug the 120 volt power cord from the electrical outlet, and disconnect the power supply
connector from either the Y-cable connector or motor connector.
2. Depending on the style purchased, the battery compartment is located in either the bottom or side
of the power supply. Locate the battery compartment and slide the battery cover over to access
the battery compartment. Your power supply will look like F
3. Snap the connection caps on the battery terminals. Place the batteries in the power supply.
4. Slide the battery cover(s) over the batteries.
5. Proceed to the Operating Instructions.
F 1
IGURE
Power (2) 9-Volt Battery
Supply Alkaline Batteries Cover
PowerReclineXR & PowerReclineXRw
®
Supply Specifications:
Input: 100-240V ~ , AC 50/60 Hz 1.5A
Output: 29V, DC 2A
18 Note: Power supplies vary by style and date of manufacturer.
1 or F 2.
IGURE IGURE
F 2
IGURE
Power Supply
Battery
(2) 9-Volt
Cover
Alkaline Batteries

Power Supply Specifications:

™
Input: AC 100V-240V ~ 50/60Hz, 1.6A
Output: DC 29V 2A
( age intentionally left blank )
19