Troubleshooting - Danby Silhouette Renoir Manual De Instrucciones

TROUBLESHOOTING

Hours of operation:
Monday to Thursday 8:30 am - 6:00 pm Eastern Standard Time
Friday 8:30 am - 4:00 pm Eastern Standard Time
Information in this manual is subject to change without notice.
PROBLEM
No power
Cabinet temperature
is too warm
Silhouette Consumer Care: 1-844-455-6097
POSSIBLE CAUSE
• A fuse in your home may be
blown or the circuit breaker
tripped
• Power surge
• Plug not fully inserted into wall
outlet
• Power is not turned on
• Temperature is set too high
(warm)
• Door is not shut properly or
opened excessively
• Exhaust vent is obstructed
• Recently added a large
quantity of warm beverages to
the cabinet
• Replace fuse or reset circuit breaker
• Unplug the wine cooler, wait a few
seconds and then plug it back in
• Make sure the 3-prong plug is fully
inserted into the outlet
• Ensure the ON/OFF switch is turned to
ON
• Verify the temperature control setting,
adjust if necessary
• Ensure that the door is fully closed and
that the gasket is sealing against the
cabinet. Open the doors only as needed
and for short periods of time
• Verify there is nothing blocking the front
mounted exhausting vent
• Limit the quantity of warm beverages
being introduced to the cabinet at the
same time. Attempt to stagger the load
introduction if possible
9
SOLUTIONS