tibelec 976030/M300C Manual De Uso página 13

1. Set the function selector switch to position
2. Set the rating switch to position
3. Connect the test plungers to the diode:
(A) Test in the direct direction: connect the black plunger to the cathode and the red
plunger to the anode, measuring the voltage in the direction of a normal diode; the
screen will display 0.5 to 0.7V and the blocked direction will display "OL".
(B) Test in the opposite direction: connect the black plunger to the anode and the
red plunger to the cathode. The diode is good if the display shows "OL".
When the symbol appears, replace the battery with a new one.
1. Set the selector switch to Off.
2. Loosen the 2 screws on the back of the tester.
3. Open and replace the battery in the corresponding area with a battery of the
same type (1xA23 12V).
4. Tighten again.
The fuse rarely needs to be replaced and practically only blows due to an
operating error. To replace it, follow the same instructions as for replacing the
battery.
The consumer is obliged by law to recycle all used batteries and accumulators.
It is forbidden to throw them in the ordinary bin! Refer to the environmental
protection details.
Imported by tibelec 996 rue des hauts de Sainghin CRT4
Protected by
standard fuse
Certified in
accordance with
European standards
Risks resulting from
hazardous voltages
59262 Sainghin en Mélantois - France
Ω
Class II equipment
without ground
connection
Do not dispose of
appliances bearing
this symbol with
domestic waste.
Use a suitable
collection point.
13