Error Messages; Waste Disposal - Beninca CP.BULL8 OM Manual Del Usario

In the event of malfunctions, by pressing key + or - the status of all inputs (limit switches, control and safety) can be displayed. One
segment of the display is linked to each input. In the event of failure it switches on according to the following scheme.
N.C. inputs are represented by the vertical segments. N.O. inputs are represented by the horizontal segments.
If a transmitter code is already stored in the receiver, the radio remote copy can be carried out (without accessing to the control unit).
IMPORTANT: This procedure should be performed with gate leaves open, during the TCA dwell time. Proceed as follows:
1 Press the hidden key of the already memorised transmitter.
2 Within 5 seconds, press the key of the already memorised transmitter which corresponds to the channel to be matched with the new
transmitter code. The flashing light switches on.
3 Within 10 sec, press the hidden key of the new transmitter.
4 Within 5 sec, press the key of the new transmitter to be matched to the channel selected at point 2. The flashing light switches off.
5 The receiver memorises the new transmitter and exits immediately the programming mode.
The control unit checks the correct operation of the safety devices. In the event of faults the following messages can be displayed:
Motor
Err1
Error, PHOT O circuit check
Err4
Error, PHOT C circuit check
Err5
Error, encoder
ENC
Obstacle detection
Amp
F1 Protection fuse for motor and blinker
F2 Protection fuse of accessories and signals
F3
Protection of 230V/115V line
If the product must be dismantled, it must be disposed according to regulations in force regarding the differentiated waste disposal and
the recycling of components (metals, plastics, electric cables, etc..). For this operation it is advisable to call your installer or a specialised
company.
18
diAGNoSTiCS
SWO SWC
P.P.
PHOT-O
PHOT
REmoTE CoPY oF TRANSmiTTER CodES

ERRoR mESSAGES

Technical assistance is required.
Check connections, alignment of PHOT O photocell or obstacle present.
Check connections, alignment of PHOT C photocell or obstacle present.
Error to connection or faulty encoder.
An obstacle present is indicated (anti-crash device).
FUSES

WASTE diSPoSAL

PED
STOP
DAS