Installation And Connection; Installation Information; Electrical Installation - Oase LunAqua Terra Instrucciones De Uso

Symbols on the unit
The warning symbols on the unit have the following meaning:
Risk of personal injury if used incorrectly
Incorrect use of the unit can cause injury or damage to assets. Always read the instructions for use first.
The symbols on the unit relating to its use have the following meaning:
Protection against the ingress of splash water. Suitable for permanent use under water up to a depth of 1 m.
Protection against touching dangerous components with objects up 1 mm diameter. Splash-water protected
on all sides.
Protection against contact by the insulated housing (protection class II).

Installation and connection

Mechanical installation
All dimensions in millimetres (mm).
B

Installation information

The lamps are fitted with installation clamps. No other fastening means are approved. They can be fitted into the
•
floor, to the wall or ceiling consisting of rigid materials, such as stone, wood, plastics.
The connection cables of the lights can be routed directly in the ground or in the sand/gravel bed. It might be advan-
•
tageous to route the cables in a protective tube to prevent damage.
Place the plug-in transformer and the connector at a place protected from the influence of weather.
•
How to proceed:
Sketch the installation locations of the plug-in transformer, connector and individual lamps.
•
Check that the cable lengths are sufficient for the planned installation. Extend the set, if necessary, with correspon-
•
ding extension cables or additional lamps from the Oase accessories range.
Mark installation holes and drill using a drill bit suitable for the individual base material.
•
Hole diameter for the lamp: 40 mm.
Depth of the hole: min. 20 mm.
Hole diameter for the connection cable: 20 mm.
Lead the connection cable through the hole.
•
Insert the lamp in the drilled hole such that the lamp makes contact with the installation surface. If necessary,
•
slightly press the wings of the clamping spring against the housing using a screw driver.

Electrical installation

C
How to proceed:
Route the lamp connection cables to the connector.
•
Connect the plug of the individual lamps to the connector outputs, and secure each connection with the union nut.
•
Hand-tighten the union nut (splash-water protection!).
Close outputs, which are not used, by means of the protection cap (splash-water protection!).
•
Connect the connection cable of the connector to the plug-in transformer. Hand-tighten the union nut (splash-water
•
protection!).
– Install the transformer at a minimum safety distance of 2 m from the water.
- GB -
9