Beurer BF 520 Guia De Inicio Rapido

WARNING
READ ALL INSTRUCTIONS FOR THE SCALE BEFORE USING THIS
QUICK REFERENCE GUIDE.
If you no longer have the instruction manual in your possession, contact Beurer customer service.
This quick guide is not a substitute for reading and understanding the instruction manual.
1
Device description
1. Display
2. Conductors
3. "Down" key
4. "SET" key
5. "UP" key
6. Body fat %
7. Muscle percentage
8. Body Mass Index
9. Body water %
10. Bone mass
11. Active metabolic rate
12. Weight
13. Memory position
6
7
8
13
2
Battery installation
1. If present, remove the battery insulating strip or remove the
battery's protective film and insert the batteries according to
the polarity.
2. Replace battery cover.
3. Replace batteries when "Lo" is displayed.
3
Setting measurement unit
You can switch to "pound", "stone" and "kilogram" (lb, st:lb,
kg) by switching on the scale and immedialely pressing the
or button.
4
Measuring weight only
1. Stand on the scale without moving and distribute your weight
evenly on both legs. The scale immediately begins to measure
your weight. After flashing, the weight is established.
2. The scale switches off a few seconds after you step down.
5
Setting user data
Your personal parameters must be stored in order to measure
body fat and other physical data.
1. Switch on your scale (tap the weighing area) and wait until
"0.0" is displayed.
2. Then press "SET". Now the first memory preset flashes in
the display.
Manufactured for: Beurer North America LP, 900 N Federal Highway, Suite 300, Hallandale Beach, FL, 33009
www.beurer.com
Questions or Comments? Contact Beurer Customer Service at 1-800-536-0366 or at info@beurer.com
Quick Start Guide
Body analysis scale BF 520
2
12
3 4 5
3. Select the desired preset by pressing the buttons "up"
or "down"
button.
4. The following steps will allow you to select your desired
1
settings with the "up"
with "SET":
• Memory position
• Height in inches or centimeter
• Age in years
• Gender setting for "Woman" or "Man"
• Activity mode
The scale is ready for measuring.
Measuring weight, body fat, body
6
water, muscle percentage, bone mass,
BMI and active metabolic rate
9
Your personal parameters must be stored (see no. 5
10
Setting user data).
1. Switch on your scale and click "SET".
11
2. Select the memory preset where your basic personal data is
stored by pressing the "up"
The data is displayed consecutively until "0.0" appears.
3. Step onto the scale barefoot and make sure you're standing
on both conductors.
4. First your body weight is calculated and displayed.
5. Remain on the scale and avoid moving; your body fat is being
analyzed. This may take a few seconds.
6
7
8
The following data will be displayed:
3. "Down" key ( )
4. "SET" key ("SET")
5. "UP" key ( )
6. Body fat %
7. Muscle %
8. Body Mass Index
9. Body water %
10. Bone mass
11. Active metabolic rate
and confirm the desired preset with the "SET"
or "down"
or "down"
3 4 5
buttons and confirm
button repeatedly.
9
10
11