Publicidad
Idiomas disponibles
Idiomas disponibles
EN
the process.
Do not modify the machine; unauthorised
parts have not been tested and approved.
Mainly use:
•
No unauthorised saw blades
•
No unauthorised safety systems 7
•
Always use the supplied safety systems!
•
Always use a cavity blade for scalloping.
46 Wear ear protectors. The following facors can
be of influence in producing noise:
•
The kind of material to be cut
•
The sawblade
•
The force of which the workpiece is fed
Loud noise can lead to hearing damage.
Ensure that you wear ear protectors.
Ensure that the cavity blade is not bent,
this can also cause noise.
47 Residual risks
The following risks are inherent to the use of
these machines:
•
Injuries caused by touching the rotating
parts
•
Injuries caused by disruption of the cutting
blade
These risks are most evident:
•
Within the range of operation
•
Within the range of the rotating machine
parts
In spite of the application of the relevant
safetyregulations and the implementation of
safety devices, certain residual risks cannot
be avoided. These are:
•
Impairment of hearing.
•
Risk of accidents caused by the
uncovered parts of the rotating cutting
blade.
•
Risk of injury when changing the blade.
•
Risk of squeezing fingers when opening
the guards.
Transport
Before all work on the machine, pull the
mains plug.
Check that all locks and tensioning devices are
secure:
•
Turn the locking knob on the turntable
counterclockwise
•
Slide the machine completely towards
8
yourself
•
Turn the locking knob on the turntable
clockwise to lock the slide-function
•
Unlock the pin on the right hand side of the
machine
•
Push the button in the handgrip to unlock the
saw blade protection
•
Push the machine completely downwards
•
Lock the pin on the right hand side again
Only lift the machine by the solid underside of the
machine.
While the machine is in use
With frequent use of the machine, do not let
routine lead to mistakes. Remember that a slight
lack of concentration can lead to serious injuries
in a fraction of a second.
•
Before beginning to saw, make sure that the
protective hood is in the right position.
•
Before cutting the first cut, let the machine run
for a short while. If you hear any unusual
sounds or observe any strong vibration, turn
the machine off and take the plug out of the
socket, and then find the cause of the
problem. Do not switch the machine on again
until the cause has been found and the fault
repaired.
•
Make sure that the piece of work being sawn
off does not get stuck in place, do not hold it or
clamp it and no not secure it against the stop.
It must be able to move freely along the side
of the saw blade. When this is not possible the
piece of work being sawn can be trapped by
the saw blade and be flung about.
•
Avoid placing your hands anywhere where in
the case of a sudden movement one or both
hands can come into contact with the saw
blade.
•
Let the saw get up to full revolutions before
you start sawing.
•
Press the saw head downwards so that the
motor is not overloaded and the saw blade
does not get jammed.
•
If you need to remove jammed material, first
let the saw blade stop turning completely,
switch the motor off and take the plug out of
the socket.
•
At the end of the sawing process, keep the
saw head downwards, switch off the machine
and wait until all moving parts has come to a
stop before you take your hands off the
Publicidad
