Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
13
1 / 4 "
m )
( 6 m
Place tip of the drill bit (1/4") against
the mounting hole mark on the wall or
the masking tape. Drive the drill bit
through each mounting hole mark.
CAUTION: Do not drill into a water line!
16
4
10
T-13
7
Wrap one layer of Plumber's Tape
T-1 (included) onto the threaded lower
side of the shower arm. Connect the
Pivot Ball (4) to the shower arm. Tighten
with Adjustable Wrench (T-13).
Place Mounting Face Plate (7) into
Bottom Mounting Bracket (10).
14
Insert Screw Anchors (8). And gently
tap anchors into the holes with
Hammer T-14 (Not included).
17
T-1
19
Tighten set screw on the side of
Diverter Valve (19) with 3/32" Allen
Wrench T-3 (Included).
8
×2
T-14
T-3
10
3/32"
13
15
9
T-10
Use Philip Screwdriver T-10
(Not included) to gently secure bracket
to wall with 2 screws (9).
18
16
Loosen the wing nut of the Adjustable
Shower Arm (16) and adjust the gear
joint to a suitable height and tighten
the Shower Arm Adjuster (17) wing nut.
17
Publicidad
Tabla de contenido
