Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION — TIPS FOR REMOVAL OF OLD SHOWER:
Always turn off water supply before removing existing diverter or disassembling the valve.
Open shower handle to relieve water pressure and ensure all water has been drained.
Option 1: Easy Install（No drilling required）
1
T-12
Remove the existing showerhead
arm by turning it in a counter
clockwise direction.
Note: A channel lock wrench T-12
(Not included) may be required.
4
l e s s
t h a n
1 - 3 /
8 "
1 - 7 /
8 " - 4
"
Choosing the correct length of
shower arm.
Measure the distance between the
1/2" - 14 NPT (National Pipe Thread) in
wall water supply elbow (not included)
and the nished wall surface. If the
measurement is less than 1-3/8" choose
6" shower arm (1). If the measurement
is between 1-7/8"-4" choose 8" shower
arm (2).
INSTALLATION
2
Prepare for installation.
5
If the wall surface is the same between
the shower arm and the bottom
mounting brocket, use 6" Shower
Arm (1).
7
3
2
8" Shower Arm
There are two optional shower arm
for your choosing: 6" Shower Arm (1)
and 8" Shower Arm (2).
6
1
If installing in a berglass or acrylic
shower enclosure where the shower
arm is mounted on sheet rock or tile,
use 8" Shower Arm (2).
6" Shower Arm
1
2
Publicidad
Tabla de contenido
