Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
To ensure safe operation and service of the meter, please follow
these instructions. Failure to observe these warnings can result
in severe injury or death.
• Before every use, verify meter operation by measuring a
known voltage or current.
• Never use the meter on a circuit with voltages that exceed the
category-based rating of this meter.
• Do not use the meter during electrical storms or in wet weather.
• Do not use the meter or test leads if they appear to be damaged.
• Use only with CAT III- or CAT IV-rated test leads.
• Ensure that meter leads are fully seated and keep fingers away
from the metal probe contacts when taking measurements.
• Do not open the meter to replace batteries while the probes
are connected.
• Use caution when working with voltages above 25 V AC RMS
or 60 V DC. Such voltages pose a shock hazard.
• To avoid false readings that can lead to electric shock, replace
batteries when a low-battery indicator appears.
• Do not attempt to measure resistance or continuity on a live circuit.
• Always adhere to local and national safety codes. Use personal
protective equipment to prevent shock and arc blast injury
where hazardous live conductors are exposed.
AC (alternating current)
Resistance (in Ohms)
Double-insulated Class II
Warning or caution
V
Voltage (volts)
°F/°C
Temperature (Fahrenheit/Celsius)
AC
AC (alternating current)
Negative reading
Auto-ranging
Low battery
°F
Degrees (Fahrenheit)
M
Mega (value × 10
m
milli (value × 10
A
Amps
4
WARNINGS
SYMBOLS ON THE METER
SYMBOLS ON THE LCD
)
6
)
-3
DC (direct current)
Audible continuity
Ground
Risk of electric shock
A
Amperage (amps)
DC
DC (direct current)
Data hold
MAX Maximum value hold
Audible continuity
°C
Degrees (Celsius)
k
kilo (value × 10
V
Volts
Ohms
)
3
Publicidad
Tabla de contenido
