Storage; Troubleshooting; Specification; Technical Specifications - Furrion FGHWCLDA-BL Manual De Instrucciones

Storage

Dry all surfaces and burner box, then spray surfaces with cooking oil substance to preserve the surface from rusting during
long term storage. Wipe off oil coating before reuse.

Troubleshooting

Before calling for service, review this list. It may save you both time and expense. This list includes common experiences that
are not the result of defective workmanship or material in your appliance.
Problem
Surface burners do not light
Surface burner flame burns half
way around
Surface burner flame is orange

Specification

Optional power Gas power
Left and Right Burner: 6500 BTU
BTU/HR
Front Burner: 8000 BTU
Fuel / Power
Propane
Inlet pressure 10" WC Min to 13.8" WC Max
Power input 12V DC < 2 Amp
This appliance conforms with the directives: ANSI Z21.57a-(2012) Rec / CAN1-1.16-M79 (R2011)
Surface control knob has not been completely turned to
position until burner ignites and then turn control to desired flame size.
Ensure gas supply valve is open.
Burner ports or slots are clogged. With the burner off use a small-gauge wire or needle to clean ports or slots.
Low gas supply level in cylinder.
Moisture is present on the burner, dry burner thoroughly.
Burner ports or slots are clogged. With the burner off clean ports with a small-gauge wire or needle to clean ports or
slots.
Moisture is present after cleaning. Lightly fan the flame and allow burner to operate until flame is full. Dry the burners
thoroughly.
Dust particles in main line. Allow the burner to operate a few minutes until flame turns blue.
In coastal areas a slightly orange flame is unavoidable due to salt air.

Technical Specifications

Possible Cause/Solution
position. Push in and turn the surface control knob to
13