Cleaning Of The Oven - Bartscher 296215 Manual De Instalación, Uso Y Mantenimiento

6.4.

Cleaning of the oven

When the oven is cold remove bottom and guides.
After cleaning switch the empty oven to avoid
corrosion.
Follow the instructions below:
Remove the oven bottom (A) and grill (B)
and clean them thoroughly.
Clean the oven interior from any burnt
residuals which may disturb correct
operation.
Clean the surface and replace the oven
elements.
7. PROBLEMS DURING OPERATION
The information below is provided to recognize
and repair any failures that may occur when
operating the appliance.
Problem
The heating plates do not work.
The heating plates remain hot.
The oven heating coils do not
work.
The oven does not reach the
preset temperature.
Some of the failures can be repaired by the user,
others require thorough specialist knowledge.
Such problems may be solved exclusively by the
qualified personnel.
Cause
The electrical connection is not
correct.
Activation of temperature
limiter.
Damaged switch.
Disturbance of the heating
plate operation
The electrical connection is not
correct.
Activation of temperature
limiter.
Damaged switch.
Damaged operational
thermostat.
9
ENGLISH
B
Solution
Check connection of supply cable.
Contact the service company.
Wait until the thermostat in the
heating plates restores normal
operation.
Replace the part.
Contact the service company.
When problem persists
contact the service company.
Check connection of supply cable.
Contact the service company.
Wait for the oven to cool down. Then
reset the thermostat (see special
section).
Replace the part.
Contact the service company.
Replace the part.
Contact the service company.
A
ID 03
GB